2020 and older models
Use blue wire tap included to attach to the very bottom wire of this connector, wire color may be different depending on model, in this example, it is the white wire.
Install Location: Behind Seat
Install Location: Rear
2021 and newer models
Install Location: Behind Seat
- Mount the black box behind the seat where you would like it
- Connect the shorter cable with a 3 pin connector to the connect out of the black box. This should be the one with ring terminals. This should run to the bus bar under the center console. The black wire is ground, read is always on positive, the yellow wire is the ignition on only positive wire. You should use all 3 posts on the bus bar when installed correctly and device should only work when the machine is in the on state (running or not running)
- Plug the longer 3 pin cable into the last two ports coming out of the box. Route this cable through the rear of machine to the rear left side of machine. You should be able to route this behind the clutch box where the other factory cables are routed, it should come out near a sensor connector as pictured below.
- Unplug cable from sensor, there is a locking tab on it, so be sure you release that then squeeze connector and pull.
- The short cable that has 3 connectors on it will go inline with this sensor. One end connecting to the sensor, other end to the cable you disconnected from sensor, then the last cable which is a 1 pin connector goes to the long cable you routed from front of machine.
- The last cable is a 2 pin connector, it plugs into the cable you routed from the front of machine, this cable has bare cut wires at the end. This is to wire to your accessories you want to turn on when machine is put in reverse.
- Once complete, you should be able to turn machine on and put it in reverse to active module.
